Help
Require Assistance? Read the Beginners Guide to RouterForums.com
RouterForums.com - Router and Woodworking Discussion Community

Go Back   Router Forums > Routers > Jigs and Fixtures
IconIt appears you arenít a registered member of the Router Forums community. Why not spend less than a minute and register for the oldest and largest router and woodworking community on the web! Join in over 29,500 discussions with over 65,000 woodworkers. If youíre an experienced or beginner woodworker, your questions and knowledge is always warmly welcomed by our community. Register now for your FREE account!

Tongue and Groove Jig

This is a discussion on Tongue and Groove Jig within the Jigs and Fixtures forums, part of the Routers category; I've 3/4" x 4' wood planks to join with varying widths. Kind of decided on ...


  • Replies: 0, Views: 1488

New Reply
 
LinkBack Thread Tools Display Modes
Old 04-05-2011, 03:17 PM   #1 (permalink)
Registered User
 
Join Date: Jul 2008
Country: United States
First Name: Allen
Posts: 3
anyducks is on a distinguished road

Default Tongue and Groove Jig
Report Post Report This Post!

I've 3/4" x 4' wood planks to join with varying widths. Kind of decided on tongue and groove for the joint. Wondering if anyone has suggestions on a jig to get consistent tongues and grooves? When finished a plank will be 10.5" width. Router is mounted under the table and I am using a fence.

The jig I have in mind will keep the wood being routed flat and not allow it to rise while being feed. Also, keeps the bit away from fingers. Jig / guide will be mounted to the fence 3/4" from the top of the table. The wood feeds flush with the top knifve for the tongue bit.

There's about 80' of planks to run. Some will be cut on both sides.
Does this seem correct? Have I missed something?

anyducks is offline  
Sponsored Advertisement - Register now to remove this advertisement.
** Please be sure to read our Disclaimer at the bottom of the page. **
These advertisements are only displayed to guests, register now for your FREE account on the worlds largest router and woodworking community!
New Reply

Bookmarks

Go Back   Router Forums > Routers > Jigs and Fixtures
IconIt appears you arenít a registered member of the Router Forums community. Why not spend less than a minute and register for the oldest and largest router and woodworking community on the web! Join in over 29,500 discussions with over 65,000 woodworkers. If youíre an experienced or beginner woodworker, your questions and knowledge is always warmly welcomed by our community. Register now for your FREE account!

Tags
jigs, tongue and groove


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
First Box Joints w/a Hart Design Jig Wild Rag Jigs and Fixtures 2 03-23-2009 08:54 AM
homemade tongue and groove panels overthehill Introductions 5 01-22-2009 11:56 PM
New to the forum - Advise PLEASE about Tongue and Groove Flooring Darby Introductions 7 03-25-2007 04:07 PM
Spline vs. Tongue & groove wanart General Routing 1 02-28-2006 06:22 AM
Tongue and groove bits archer_456 General Routing 4 02-18-2005 05:51 AM