| |
| | Register Now!It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community! ** Registration removes majority of the website advertisements ** | |
02-14-2007, 07:54 PM
| #1 |
| Registered User New Member |  Those of you who have the Oak Park Panel System: Those of you who have the Oak Park Panel System: Have anyone used other cutting bits to cut rails & stiles other than what Oak Park sells? I’m very interested in the system but looking for other bits that could be used. What I have found checked with Oak Park and there cutter mesures 1-11/16” in diameter; I have a cutter, which measure 1-3/4” in diameter. Would a 16th of inch over or under make that much different? Mossy Oak  |
| Top - Reply with Quote |
 Sponsor Post
| |
| Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Router Forums | |
|
02-14-2007, 08:08 PM
| #2 |
| Forum Contributer Supreme Forum King  | Hi Mossy Not at all, it would just be 1/32" shorter on the rails ends. Bj 
__________________ Bj Last edited by bobj3; 02-14-2007 at 10:32 PM. |
|
| Top - Reply with Quote |
New Reply |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Outlook Express problems | BrianS | Lobby | 6 | 01-06-2008 07:23 AM |
| Bits for the Oak Park raised panel system | Mike | Router Bits - Types and Usage | 14 | 12-23-2007 08:04 PM |
| Oak Park Raised Panel Jig.... | tpyke | Table-mounted Routing | 8 | 12-06-2007 11:43 AM |
| oak park vaccuum system | angus | Table-mounted Routing | 2 | 01-26-2007 01:02 AM |
| research for raised panel doors | presumed_druid | Table-mounted Routing | 4 | 01-13-2006 10:47 PM |
Linear Mode
