| | Register Now! It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community!
** Registration removes majority of the website advertisements ** | |
| ||||||
| This is a discussion on Details of Dado jig please? within the Jigs and Fixtures forums, part of the Routers category; Cabminetman, I 've modified the pics & Text on my webpage per your recent comment ... |
New Reply |
| | LinkBack (1) | Thread Tools | Display Modes |
04-30-2007, 12:33 AM
| #11 (permalink) | ||
| Banned   |
Cabminetman, I 've modified the pics & Text on my webpage per your recent comment (email): "The arm is out of one piece of plywood, with the center cut out of it. Like it could be dropped on the TS for the long cuts, and then jig saw across for the two ends. The one I used for the drawing was cut out of plywood but from the end down both sides. Since the end was open, I had to put that top piece to keep the spacing." Thank you very much... | ||
|
 Sponsor Post
| ||||
 Sponsored Links __________________ This advertisment post is not shown to registered members. Register your free account today and become a member of Router Forums | ||||
New Reply |
| Bookmarks |
LinkBacks (?)
LinkBack to this Thread: http://www.routerforums.com/jigs-fixtures/4371-details-dado-jig-please.html | ||||
| Posted By | For | Type | Date | |
| Dado on Malamine - Woodworking Talk - Woodworkers Forum | This thread | Refback | 01-15-2010 09:39 AM | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dado Jig for Plunge Router | bobj3 | Jigs and Fixtures | 35 | 01-22-2010 01:01 PM |
| Router Table Dado Jig | RoyBullets | Jigs and Fixtures | 11 | 06-16-2008 08:41 PM |
| FREUD Dado Sets | sawstop | Tools and Woodworking | 4 | 10-30-2006 03:57 PM |
| Router Adjustable Dado Jig | Barry_White | Jigs and Fixtures | 4 | 02-07-2005 01:17 AM |
| Dado blades and other table saw specialties | Mike | Tools and Woodworking | 3 | 01-05-2005 08:07 PM |
Linear Mode
