| |
| | Register Now!It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community! ** Registration removes majority of the website advertisements ** | |
| ||||||
| Jigs and Fixtures This area will be directed towards the art of designing specific jigs and fixtures. Bob and Rick say, "if the specific operation is to make more than one piece the same size and shape then chances are you need a jig and/or fixtures." |
New Reply |
| | Thread Tools | Display Modes |
11-11-2007, 07:43 PM
| #1 |
| Registered User Forum Geek |  Fluting Jig Anyone have any plans for making a fluting jig that I can use to flute my vases that I turn on the lathe. Not a fluting jig that you can cut flutes on a straight spindle, I use one of them often. Mitch |
| Top - Reply with Quote |
 Sponsor Post
| |||
| Advertising
| Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Router Forums | ||
|
11-11-2007, 08:49 PM
| #2 |
| Registered User Forum King  | Hi Mitch. Not sure I understand the difference. Are you talking about doing straight flutes or 'barley twist'? If you're looking for a straight flute jig, there's a way of mounting a router on an angled base to present the fluting bit side on to the leg while mounted on the lathe. Otherwise, you might need to go for one of those devices that mount a router over the turned work piece and are then hand cranked along while the piece rotates. Bj will point you in the right direction if this is what you're after.
__________________ Pete I've cut it twice and it's still too short! But only at one end. |
|
| Top - Reply with Quote |
|
11-11-2007, 09:00 PM
| #3 |
| Retired Moderator Supreme Forum King  | Mitch, scroll down to the center of this link and you will see a drawing for one. Corey http://www.extremehowto.com/xh/artic...ticle_id=60434
__________________ My Carving Website: The Iowa Woodcarver http://iowacarver.tripod.com/ My Shop Website - Woodshop 51503 http://woodshop51503.tripod.com/ |
|
| Top - Reply with Quote |
New Reply |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fluting Jig for use on Lathe | nzgeordie | Jigs and Fixtures | 4 | 01-01-2007 10:14 PM |
| Repetitive Fluting | fibertech | General Routing | 2 | 10-15-2005 08:48 AM |
Linear Mode
