| |
| | Register Now!It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community! ** Registration removes majority of the website advertisements ** | |
| ||||||
| Jigs and Fixtures This area will be directed towards the art of designing specific jigs and fixtures. Bob and Rick say, "if the specific operation is to make more than one piece the same size and shape then chances are you need a jig and/or fixtures." |
New Reply |
| | Thread Tools | Display Modes |
02-11-2005, 07:43 PM
| #11 |
| Registered User New Member |  Hand Screw Clamps Thanks Ed, Mike, & Aniceone2hold for the reply and information. I had built a jig for the drill press that pined the side hole so I could move the stock up and down. I'm now going to build a stand alone jig for my router. (I never give up.) It may take a week or two but I'll post a picture of it when it works.--Thanks again---- |
| Top - Reply with Quote |
 Sponsor Post
| |||
| Advertising
| Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Router Forums | ||
|
02-11-2005, 08:24 PM
| #12 |
| Senior Moderator Supreme Forum King  | Hey Woofman, have you tried drilling a starter hole and using a spiral router bit in your drill press? It would be slow cutting but should give you nice clean angled holes.
__________________ Mike |
|
| Top - Reply with Quote |
New Reply |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Right angle clamps | rharveyva | Starting Off | 2 | 03-28-2008 10:28 PM |
| Quick-grip clamps repair and improval | simplenik | Tools and Woodworking | 9 | 06-05-2007 08:19 AM |
| Toggle Clamps (Update) | Pop_pop1 | Table-mounted Routing | 1 | 08-29-2005 07:52 AM |
| T Track Toggle Clamps | Pop_pop1 | Table-mounted Routing | 4 | 07-29-2005 03:22 AM |
| what clamps are most usefull | matey | General Routing | 8 | 01-27-2005 01:36 PM |
Linear Mode
