| |
| | Register Now!It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community! ** Registration removes majority of the website advertisements ** | |
| ||||||
| Portable Routing Discussion area on the Portable Router and its applications. Bob and Rick say, "If the piece is bigger than the router then chances are it should be routed with the portable router." |
New Reply |
| | Thread Tools | Display Modes |
02-05-2006, 07:32 PM
| #1 |
| Registered User New Member |  How to make a template I have a project and would like input. I need to build a template to assist putting additional vents in the soffit of my house. I plan to use a small trim router to cut a 6x15 hole about every 5 feet. How to hold the template in place while I cut upsidedown. Any input will help. Sorry Wrong forum Last edited by JMRagan; 02-05-2006 at 07:36 PM. Reason: Wrong Forum |
| Top - Reply with Quote |
 Sponsor Post
| |||
| Advertising
| Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Router Forums | ||
|
02-09-2006, 09:46 PM
| #2 |
| Registered User New Member | You could try this idea,make a template from 1/4" plywood, make the cut out big enough to allow for the router base and use a plung bit,Attach with double sided tape or small screws that would be covered by your grill if you plan on using one.I use double sided carpet tape works well.Hope this helps the Restorer |
|
| Top - Reply with Quote |
|
02-10-2006, 12:43 PM
| #3 |
| The Router Guys Forum King  | I think small screws are the best bet. You don't want this template moving around.
__________________ Rick and Bob The Router Guys Click here to send a greeting card to friend or relative. |
|
| Top - Reply with Quote |
New Reply |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Looking for a CAD file to make a template | tearen | Guide Bushings and Templates | 1 | 06-11-2008 11:10 AM |
| Mortise Template | JDługosz | Jigs and Fixtures | 14 | 09-27-2007 02:32 AM |
| Template Routing | FlyFAmerica | Portable Routing | 8 | 01-22-2007 09:57 PM |
| Make a template to create a filler piece? | Ric Naff | Jigs and Fixtures | 3 | 01-12-2006 08:56 PM |
| Template, how to make? | smacmullin | Jigs and Fixtures | 2 | 11-08-2005 05:52 PM |
Linear Mode
