| ||||||
It appears you aren’t a registered member of the Router Forums community. Why not spend less than a minute and register for the oldest and largest router and woodworking community on the web! Join in over 29,500 discussions with over 65,000 woodworkers. If you’re an experienced or beginner woodworker, your questions and knowledge is always warmly welcomed by our community. Register now for your FREE account!| This is a discussion on Looking For Special Material within the Project Plans and How To forums, part of the General Woodworking category; After finally getting a chance to upgrade my shop, I have an idea that I ... |
New Reply |
| | LinkBack | Thread Tools | Display Modes |
05-15-2007, 10:56 PM
| #1 (permalink) | ||
| Registered User   |
After finally getting a chance to upgrade my shop, I have an idea that I need help finding. Does anyone know where to find whiteboard material? I want to put a dry erase face on one of the cabinet doors. My local woodworking stores do not have this (Rockler, Woodcraft, etc.) Thanks in advance. -Derek | ||
|
|
Sponsored Advertisement - Register now to remove this advertisement.
|
|
** Please be sure to read our Disclaimer at the bottom of the page. **
These advertisements are only displayed to guests, register now for your FREE account on the worlds largest router and woodworking community! |
|
05-16-2007, 01:02 AM
| #2 (permalink) | ||
| Forum Liaison   |
Derek, you should find the white board at a craft store like Michael's or one of the office supply places. You should be able to use the markers with smooth white Formica as well and you can get that at HD, Lowe's or most lumber yards.
__________________ Mike "Living in the D" (this means Detroit!) "It's fine to disagree with other members as long as you respect their opinions" | ||
|
|
|
05-16-2007, 07:46 AM
| #4 (permalink) | ||
| Retired Moderator   |
Yup, Home Depot sells the dry erase board. Not sure if they sell it in 4 x 8 sheets but I know they do in 2 x 4 sheets. Corey | ||
|
|
|
08-30-2012, 01:29 PM
| #5 (permalink) | |||
| Registered User  |
Quote:
| |||
|
|
New Reply |
| Bookmarks |
| ||||||
It appears you aren’t a registered member of the Router Forums community. Why not spend less than a minute and register for the oldest and largest router and woodworking community on the web! Join in over 29,500 discussions with over 65,000 woodworkers. If you’re an experienced or beginner woodworker, your questions and knowledge is always warmly welcomed by our community. Register now for your FREE account!| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Delta P-20 Material Holdown Clamping Screw | rstermer | Wood Scrolling | 6 | 06-10-2008 06:27 PM |
| router table top material | mharwell01 | Table-mounted Routing | 1 | 01-26-2008 04:14 PM |
| Plastic router fencing material | mstevensjr | General Routing | 6 | 09-02-2005 03:28 PM |
| Table Top Material | rh111 | Table-mounted Routing | 4 | 04-19-2005 03:35 AM |
| Material For Router Fence | kvc | Table-mounted Routing | 7 | 10-11-2004 07:52 PM |
Looking For Special Material 
Linear Mode
