| |
| | Register Now!It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community! ** Registration removes majority of the website advertisements ** | |
04-19-2008, 09:54 AM
| #1 |
| Registered User Forum Fanatic |  Flash trim bit to Venner Please let me know... Is it possible for me to use Flash trim bit to 12mm Venner(*1) edge ? Thank you. (*1) I do not know how to say it. Please see attached. |
| Top - Reply with Quote |
 Sponsor Post
| |
| Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Router Forums | |
|
04-19-2008, 11:44 AM
| #2 |
| Senior Moderator Supreme Forum King  | Yes Benny, you can use flush trim bits for trimming veneer. This is the reason they were made.
__________________ Mike |
|
| Top - Reply with Quote |
|
04-20-2008, 03:10 AM
| #3 |
| Registered User Forum Fanatic | Mike san Thank you for answer. I think I could have done well. Please teach me again. Thank you. |
|
| Top - Reply with Quote |
New Reply |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Flush trim bits | Hamlin | Router Bits - Types and Usage | 4 | 12-01-2007 01:51 PM |
| Flush Trim Bit? | cbsjoez1935 | Router Bits - Types and Usage | 5 | 07-28-2007 11:35 AM |
| How should I trim picture frame splines? | lrr | General Routing | 4 | 02-11-2007 09:59 PM |
| Where to get a flush trim bit? | wanart | Router Bits - Types and Usage | 4 | 10-28-2006 08:39 AM |
| Floor/wall Trim | reds_21 | General Routing | 2 | 01-13-2006 08:52 PM |
Linear Mode
