Register Now!

Drew Eckhardt · 10-15-2008, 01:55 AM

What sort of problems would I expect from a 2" diameter 45 degree chamfer bit (Whiteside) which is not anti-kickback assuming a table mounted router and a few passes in 3/4" hardwood like 3/8", the rest except for 1/16", and the last finish cut?

I think my Whiteside trim + pattern bits cut better than the rest and wanted a chamfer for 3/4" stock except their's isn't anti-kickback.

**harrysin** · 10-15-2008, 08:55 AM

Providing you feed the hardwood in the correct direction, right to left, I wouldn't expect any problems at all.

10-15-2008, 01:55 AM	#1
Drew Eckhardt Registered User Dedicated Member Join Date: Aug 2008 Location: Menlo Park, CA Posts: 39 View Drew Eckhardt's Gallery	Report This Post! Not anti-kickback? What sort of problems would I expect from a 2" diameter 45 degree chamfer bit (Whiteside) which is not anti-kickback assuming a table mounted router and a few passes in 3/4" hardwood like 3/8", the rest except for 1/16", and the last finish cut? I think my Whiteside trim + pattern bits cut better than the rest and wanted a chamfer for 3/4" stock except their's isn't anti-kickback. Attached Thumbnails
	Top - Reply with Quote

10-15-2008, 08:55 AM	#2
harrysin Forum Contributer Supreme Forum King Join Date: Jan 2007 Location: Western Australia Posts: 3,238 View harrysin's Gallery	Report This Post! Providing you feed the hardwood in the correct direction, right to left, I wouldn't expect any problems at all. __________________ *Harry*
	Top - Reply with Quote

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Anyone ever tried these anti kickback rollers?	jer760	Tools and Woodworking	9	10-29-2008 09:50 PM
Introduction and questions re: kickback problems	BrettW	Introductions	2	05-05-2008 08:56 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)