| |
| | Register Now!It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community! ** Registration removes majority of the website advertisements ** | |
05-15-2008, 12:49 PM
| #1 |
| Registered User New Member |  Formula Help (radius) To figure the compound curve when designing cathedral doors ([(10/4)^2/(4-2.25)/2]+(4-2.25)/2)/2 10 dist between stiles 4-2.25 is max rail width - min rail width the answer is 1.3 I believe I am calculating this wrong. Can you help? Thanks in advance |
| Top - Reply with Quote |
 Sponsor Post
| |
| Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Router Forums | |
|
05-15-2008, 01:31 PM
| #2 |
| Forum Contributer Supreme Forum King  | Hi Thomb I'm not to sure why you are playing with the numbers,,, it takes two templates to make a cathedral door... and all the math is done for you with the premade templates.. They come in many sizes, to make a 4" wide door to a 24" wide door... Many woodworkers supply companys sell them here's just two of them.. http://www.sommerfeldtools.com/prodinfo.asp?number=TMP3 http://www.sommerfeldtools.com/prodi...p?number=CLTMP http://www.ptreeusa.com/routerAcc.htm#20262 ============ Raised Panel Door Calculato http://www.1888softwaredownloads.com...oors-4336.html 20mb file, Shareware ============ http://www.cheyennesales.com/download/rpdcalc.htm =========
__________________ Bj Last edited by bobj3; 05-15-2008 at 03:19 PM. |
|
| Top - Reply with Quote |
|
05-15-2008, 02:24 PM
| #3 |
| Registered User New Member | what was i thinking. |
|
| Top - Reply with Quote |
New Reply |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Determining a radius cut | RoyBullets | Jigs and Fixtures | 7 | 06-23-2008 08:10 AM |
| Corner Radius | bobj3 | Tools and Woodworking | 25 | 09-29-2007 05:51 PM |
| Working with radius | MiamiSnookII | Starting Off | 5 | 01-07-2006 10:20 AM |
| 3/4" Radius roundover bit with 1/4" shank | chrisogrady | General Routing | 8 | 04-01-2005 08:08 PM |
| Router Table Plate Radius | DONALD | Table-mounted Routing | 2 | 02-27-2005 09:26 AM |
Linear Mode
