| |
| | Register Now!It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community! ** Registration removes majority of the website advertisements ** | |
12-06-2007, 01:47 PM
| #1 |
| Registered User | Is there a router bit or a process that will cut a 45 degree angle on a full 3/4" board? |
| Top - Reply with Quote |
 Sponsor Post
| |||
 Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Router Forums | |||
|
12-06-2007, 03:08 PM
| #2 |
| Forum Contributer Supreme Forum King  | Hi IKE Yes, almost all mfg. of router bits make one or two..here's just two of them.. http://www.grizzly.com/products/c1135 http://www.grizzly.com/catalog/2007/Main/467 http://woodworkersworld.net/chamfer_bits.shtml http://ptreeusa.com/router_list.htm http://ptreeusa.com/ ===============
__________________ Bj Last edited by bobj3; 12-06-2007 at 03:28 PM. |
|
| Top - Reply with Quote |
|
12-07-2007, 12:18 AM
| #3 |
| Official Greeter Supreme Forum King  | Hi Ike and welcome to the forums.
__________________ Dave the "Doctor" In woodworking there is no scrap, only firewood.  |
|
| Top - Reply with Quote |
New Reply |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
Linear Mode
