| |
| | Register Now!It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community! ** Registration removes majority of the website advertisements ** | |
01-10-2008, 09:27 AM
| #1 |
| Registered User |  laminate counter top I wish to glue laminate onto a solid piece of pine and finish the edge with a ogee bit. Will the router bit cut the laminate to shape or do I have to router the edge of pine first and then very carefully glue the laminate on it and file the edges? |
| Top - Reply with Quote |
 Sponsor Post
| |||
| Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Router Forums | |||
|
01-10-2008, 09:49 AM
| #2 | |
| Forum Contributer Supreme Forum King  | Hi lyoncub The ogee bit will do the job,, but you will need to lay the laminate a bit shy of the edges,,,that's to say keep it back from the edge, laminate likes to snap off the edges if you have to much hanging over the cut... take 2 passes to get the job done  a bit of masking tape will help hold the laminate in place and give you a nice clean cut..========= Quote:
__________________ Bj | |
|
| Top - Reply with Quote |
|
01-10-2008, 10:57 PM
| #3 |
| Official Greeter Supreme Forum King  | Welcome to the Router Forums lyoncub.
__________________ Dave the "Doctor" In woodworking there is no scrap, only firewood.  |
|
| Top - Reply with Quote |
New Reply |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Thoughts on the RIDGID Laminate Trimmer.. | the2js97 | Starting Off | 3 | 05-11-2008 06:51 PM |
| Plastic laminate | S Bolton | Table-mounted Routing | 12 | 03-16-2008 06:40 PM |
| glue for plastic laminate | S Bolton | Table-mounted Routing | 8 | 09-29-2007 12:05 PM |
Linear Mode
