| | Register Now! It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community!
** Registration removes majority of the website advertisements ** | |
| ||||||
| This is a discussion on picture frames within the Table-mounted Routing forums, part of the Routers category; how to make a picture frame with curved inside and outside corners... |
New Reply |
| | LinkBack | Thread Tools | Display Modes |
05-13-2009, 06:13 AM
| #1 (permalink) | ||
| Registered User  |
how to make a picture frame with curved inside and outside corners | ||
|
 Sponsor Post
| ||||
 Sponsored Links __________________ This advertisment post is not shown to registered members. Register your free account today and become a member of Router Forums | ||||
|
05-13-2009, 08:11 AM
| #2 (permalink) | ||
| Registered User   Join Date: May 2007 Location: I was born and raised in Holland Michigan First Name: Howard Posts: 1,499  |
Hi Jerry! If you are talking about only inside and outside corners, i would think that a template would do the trick. First, i would make a 1/4 in. hardboard template and the collar would ride the template edge. You can make one for the inside, and the outside. It would insure that all 4 corners would be the same
__________________ John 3:16 Please fill out your profile, It helps us to know you better  | ||
|
|
05-13-2009, 03:12 PM
| #3 (permalink) | ||
| Registered User |
thanks, good suggestion. I'm making a combing box for the cockpit of my sailboat, and the outside frame is like a rectangular picture frame with rounded corners. I'm a newbie here and wasn't sure if members would be familiar with a combing box. i'm also a newbie to table routing. thanks for the help. | ||
|
|
|
05-14-2009, 09:33 AM
| #4 (permalink) | ||
| Forum Contributor   |
Gerry, hurry and get 10 posts in so that you can post a drawing, complete with measurements after which I promise that complete answers will be forthcoming.
__________________ Harry The best advice that I can give a newcomer to routing is, learn to use the router mounted, this can be as simple as a board held in a vice, with the router firmly attached and a simple fence held with clamps, and when he/she feels competant and confident in it's use and is familiar with all aspects of safety, THEN, and only then proceed to learn how to use the router hand held. This is MY opinion, and may or may not coincide with that of the forum management, but is based on a lifetime of woodworking. http://members.dodo.com.au/~sharry02/ | ||
|
|
New Reply |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| router bits for Picture frames | bytesnooper | Portable Routing | 4 | 02-05-2009 01:03 PM |
| Locking mitre joints for picture frames | grandsire02 | Table-mounted Routing | 3 | 08-10-2007 02:56 AM |
| Picture frames | Glenmore | Show N' Tell | 6 | 07-09-2007 06:52 PM |
| cutout for picture frames and mirrors | newbierouterguy | Router Bits - Types and Usage | 4 | 03-25-2007 07:56 PM |
| Need advice and guidance for routing picture frames | popmoon | Table-mounted Routing | 26 | 03-12-2007 12:11 AM |
picture frames 
Linear Mode
