| |
| | Register Now!It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community! ** Registration removes majority of the website advertisements ** | |
| ||||||
| Table-mounted Routing Discussions solely based on operations that are using the table-mounted router. Bob and Rick say "More than 90% of all operations using the router can be done with the table-mounted router. |
New Reply |
| | Thread Tools | Display Modes |
10-06-2005, 06:55 PM
| #1 |
| Registered User New Member |  Skil 1825 base plate I'm considering buying a router table extension for my table saw and dont have my router in my hands yet. (it is on order...) But I am wondering if it would match up with the "Porter Cable 7529/690/693 Bosch 1617/1618" Plate holes. Can anyone help? I would like to get it ordered!!! Thanks Shane |
| Top - Reply with Quote |
 Sponsor Post
| |||
| Advertising
| Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Router Forums | ||
|
10-07-2005, 01:09 AM
| #2 |
| Forum Moderator Supreme Forum King  | Welcome to the forums Shane. Here is a question. Is the table pre-cut you'll have to give us your mesurments of the hole in the table for the base it sets in. There are a number of places to order plates. How about where you order the table they should offer the plate for needs. I looked at oak park and they don't have the skil model you mentioned.
__________________ Glenmore Days without wood working are days not worth getting up for. Last edited by Glenmore; 10-07-2005 at 01:21 AM. |
|
| Top - Reply with Quote |
|
10-07-2005, 10:47 AM
| #3 |
| Registered User New Member | Thank you Glenmore for your response. As much as I would like to order the Oak Park model, it is out of my price range. Plus they don't offer a table saw extension wing model. I'll be ordering from Rockler. Just didn't want to order the "blank plate" model... I contacted them and they don’t know ether. I was hoping that there was somebody on this forum that had one and could measure it and sent it on to me. Thanks again |
|
| Top - Reply with Quote |
New Reply |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Making your own sub base plate | Mike | Guide Bushings and Templates | 9 | 08-18-2008 10:43 PM |
| choosing a base plate ... | reikimaster | Table-mounted Routing | 5 | 01-13-2006 11:37 PM |
| Finding the correct base plate | Mossy Oak | General Routing | 2 | 12-14-2005 07:40 AM |
| Centering Base Plate | -Sam- | General Routing | 15 | 01-04-2005 11:15 AM |
Linear Mode
