I mentioned building a new router table for the Kreg top and fence I purchased in my introduction post. The overall box is done and I have mounted my older Craftsman router. Since I want dress up the doors and drawer fronts ever so slightly I wanted to have use of the table. I will post a few pictures, but take note that it is no where near complete. The two top drawer spots will only have a front and will be used to set router bits into. They can be pulled out for ease of access when I am working and returned to the table when finished. The third spot on each side of the router box will have a small door and i will use these areas to store longer items, wrenches, feather boards and such. The center will be the router access and I an still trying to decide if I want it to open to the side or to lay down, (Thoughts?). the bottom box will be two doors that open left and right. When I upgrade to a Triton I will remove the old Craftsman and use it as a hand held router. This box will store that router and any others I accumulate over time nicely.
This is the first item like this I have ever built and I can't even tell you how many wrong cuts I have made, but it has still been fun.
I have lots of photos but will only post a few.
Last edited by tmyers; 02-27-2017 at 08:39 PM.