Router Forums banner

oak park tenon/coping jigs

3K views 5 replies 5 participants last post by  bobj3 
#1 ·
Does anybody have any experience with the tenon/coping jigs used on the router workshop. I am considering buying the base plate with the pre-drilled holes and these jigs, but wanted some feedback from someone with experience. They look awful handy on the show. Thanks.
 
#2 ·
The box joint jigs work very well. A friend has made dozens of small boxes with them and they are still like new. I have used them a couple times and recommend them.
 
#4 ·
Are you asking about the mortise and tension set up or the raised panel door set up. I have both and they are both easy to set up and use with vertually no measuring, only minor adjustments.
 
#6 ·
ShaneB

The sleds you are taking about can be made quick and easy, you may not want to buy one but just make one or two of them.
You will wipe them out from time to time (the back stop part ) then all you need to do is replace that part of the jig.
You can use 1/4" plastic and hard wood and a hold down clamp or two that you can get from just about any wood workers supply store.

If you would like to see one I made just repost and I will post a snapshot of it/them.


Bj :)
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top