| |
| | Register Now!It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community! ** Registration removes majority of the website advertisements ** | |
| ||||||
| Table-mounted Routing Discussions solely based on operations that are using the table-mounted router. Bob and Rick say "More than 90% of all operations using the router can be done with the table-mounted router. |
New Reply |
| | Thread Tools | Display Modes |
10-10-2004, 03:50 PM
| #1 |
| Registered User New Member |  Horizontal Router Table I will be building a Horizontal Router Table within the next few months. This will be used to make Base Moldings and Crown Moldings mostly. If you have any suggestions on the construction of this new tool please send them to me.I think ill use a Hitachi 3 1/4 hp model plunge.I ordered a catalog from RBI to see the model they offer,for some ideas. |
| Top - Reply with Quote |
 Sponsor Post
| |||
| Advertising
| Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Router Forums | ||
|
10-10-2004, 09:23 PM
| #2 |
| Registered User Jr. Member | The April 2004 FWW edition has an article on building "A versatile Router Table". This looks like a sweet, low-cost open table that allows for horizontal, overhead or vertical routing. Looks inexpensive to build as well. Page 58. |
|
| Top - Reply with Quote |
|
10-10-2004, 10:53 PM
| #3 |
| Marine Engineer Forum King  | This might give you some ideas http://www.woodhaven.com/detail.aspx?ID=91
__________________ Doug 1 John 1:9 |
|
| Top - Reply with Quote |
|
10-11-2004, 06:11 AM
| #4 |
| Router King Supreme Forum King  | Looks like it might get a little rough doing wide work. Looks like the material will need extra support to hold it into the cutter. Reminds me of a guillotine.
__________________ |
|
| Top - Reply with Quote |
New Reply |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| MLCS Horizontal Router Table | bigjoedo | Table-mounted Routing | 15 | 12-22-2007 09:41 AM |
| Motorized Router Lift - Eagle Lake Style | johnwnixon | Table-mounted Routing | 10 | 09-13-2007 07:59 AM |
| Horizontal Router Table | scrollwolf | Table-mounted Routing | 30 | 08-21-2007 05:09 PM |
| Problem mounting Dewalt Router to Caftsman Table Saw | apollo2000 | General Routing | 8 | 05-22-2007 07:42 PM |
Linear Mode
