| |
| | Register Now!It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community! ** Registration removes majority of the website advertisements ** | |
| ||||||
| Table-mounted Routing Discussions solely based on operations that are using the table-mounted router. Bob and Rick say "More than 90% of all operations using the router can be done with the table-mounted router. |
New Reply |
| | Thread Tools | Display Modes |
07-15-2007, 09:52 PM
| #11 | |
| Registered User Forum Geek  | Quote:
And while I applaud your generosity and your sense of sharing -- They are right -- you should TAKE the money - and keep a paper trail. Not everyone is as generous as you -- and if SOMEONE is going to make money off of your hard work and creativity -- it is only RIGHT that one of them be YOU. | |
| Top - Reply with Quote |
 Sponsor Post
| |||
| Advertising
|  Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Router Forums | ||
|
07-16-2007, 02:38 AM
| #12 |
| Registered User Forum Geek | Thank you Hal They said that it will appear within 6 months (and the contract is for 6 months) Dragstore Cowboy Thank you for your kind words. I'm not so much after money and I think that if other people in the forum would post there, they would also get "Top shop tip"... Regards niki |
|
| Top - Reply with Quote |
|
07-21-2007, 11:16 PM
| #13 |
| Registered User New Member | Niki, I've seen your posts on other forums and have enjoyed them. Even though I may or may not actually build or use every one of them they have all been interesting and generally have something to offer the reader. The materials you use are indeed simple but the method is clever and I can learn a thing or two from you. Thanks. Congrats on the offer from Wood magazine. Kmer |
|
| Top - Reply with Quote |
|
07-22-2007, 04:06 AM
| #14 |
| Registered User Forum Geek | Thank you Kmer Nothing makes me more happy than helping people to save their money so they can buy more tools instead of jigs that can be made very easily with very low cost and same accuracy like the "factory" ones. Yes, the materials that I use are very cheap. Usually, I don't have to go out for "shopping" (except for rollers, threaded rods and sanding paper), everything is from the "scrap box"... Regards niki |
|
| Top - Reply with Quote |
New Reply |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Router Table Help Which One! | bigroccrek | Table-mounted Routing | 25 | 04-08-2008 11:57 PM |
| First and only (I hope!) Router table | CanuckBeaver | Table-mounted Routing | 11 | 07-25-2007 03:45 PM |
| Rolling Mortise Jig - the test | simplenik | Table-mounted Routing | 9 | 07-23-2007 11:54 AM |
| Making Mortise with a router table | thdewitt | Table-mounted Routing | 9 | 07-16-2007 10:40 AM |
Linear Mode
