| |
| | Register Now!It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community! ** Registration removes majority of the website advertisements ** | |
| ||||||
| Table-mounted Routing Discussions solely based on operations that are using the table-mounted router. Bob and Rick say "More than 90% of all operations using the router can be done with the table-mounted router. |
New Reply |
| | Thread Tools | Display Modes |
04-17-2008, 08:50 PM
| #11 |
| Registered User Forum Fanatic  |  Vertical fence dimensions The fence is 14 inches high and 36 inches wide. I like to use drawer lock joints. One piece is routed flat on the table and the other is routed vertically against the fence. With a tall fence you get a lot of stability. The tall fence has a couple of tracks for stops, feather boards, etc.  Following the Sears roller cabinet theme here is a photo of my radial arm saw table. This was actually a Sears work bench. I cut the legs off and set the cabinet section into an angle iron frame with casters.
__________________ www.PeterSpirito.com |
| Top - Reply with Quote |
 Sponsor Post
| |||
| Advertising
|  Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Router Forums | ||
New Reply |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| My latest router table | deck99 | Table-mounted Routing | 4 | 04-24-2008 11:48 AM |
| Motorized Router Lift - Eagle Lake Style | johnwnixon | Table-mounted Routing | 10 | 09-13-2007 07:59 AM |
| First and only (I hope!) Router table | CanuckBeaver | Table-mounted Routing | 11 | 07-25-2007 03:45 PM |
| Problem mounting Dewalt Router to Caftsman Table Saw | apollo2000 | General Routing | 8 | 05-22-2007 07:42 PM |
Linear Mode
