Glenmore

Had to make a new piece for my cabinet door. Was going good then it happened. Had the profile down pat for the the whole molding aspect then I had to make a cut where the door frames meet. Found using my screw clamp worked well. Well all that said here is where I screwed up I did my first cut using a half inch straight bit did the cut found that had a little edge on the outside of it so went to clean it up and went deeper into the length cut. But it works if it was my own cabinets I would have remade this door and the others so they would match it does still look half decent but it is a blemish and I figured instead of a triumph I would show that we make mistakes to. But I still used mine.

Attached Thumbnails

 

__________________
Glenmore

Days without wood working are days not worth getting up for.

Advertising

Check twice!

The beauty of making mistakes is the "lesson learned".

I wish I had a nickle, for every mistake I made that I could not use, and ended up doing it again.

Thats a "kodack moment".

Have a great day
John

__________________
John

Cleaning my glasses will not make me look any better, but will make what I'm looking at better!

harrysin

As this appears to be confession time, here are some of my past mistakes when making raised panel doors, so don't feel too bad Glenmore.

Attached Thumbnails

 

__________________
Harry