Hamlin

Hi Mike,

SWEET!! Congrats again on the new TS.
I gotta agree with ya 'bout the insert(s). Some can be a bit tricky to get flat. Nice looking planer too.

Ed, the pics are back up. Sometimes certain sites do have a "maintance" time and they are down for an hr or so.

__________________
Ken

(On temporary leave of abscense)

"A VETERAN"
"Wether active duty, retired, national guard or reserve - is someone who, at one point in their life, wrote a blank check made payable to "The United States of America", for an amount of "up to and including my life". That is HONOR, and there are way too many people in this country who no longer understand it." -Author Unknown

Advertising

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Router Forums

Dr.Zook

Congrats on your new "TOYS'" Mike. I know you will enjoy them. Thanks for the great pics and review, Harry would be pleased as I am. Now we need to see some projects (with pics) off these new toys. Enjoy.

__________________
Dave
the "Doctor"

In woodworking there is no scrap, only firewood.

karateed

Lookin' very nice Mike,

Ed......:-)

AxlMyk

Going to be a while before I get another project going Doc. The shop is totally torn apart right now. That big saw takes up a lot of room, so I'm re-arranging everything.
I do plan on building a tool chest. Pics to come Harry.

__________________
Mike - Retired FoMoCo Tradesman
My Gallery @ http://www.routerforums.com/axlmyks-stuff/

curiousgeorge

Congrats on the fine saw and you are going to love the 735.

__________________
George

I did not chop down that cherry tree!!! But, since its down, can I have the wood?

DougO

Congratulations on the nice setup. Wouldn't take much for me to get jealous.

__________________
Doug

AxlMyk

I finally got a chain fall so I could hoist that 400 pound monster off the mobile base. After cutting some triangle pieces of 3/4" ply and putting them in the corners of the base, I let the saw down on it and, it rocked. No change. Well heck. I then put some thick felt table pads on the feet and let down on the base. It rocked.
Now the frustration sets in. Looking under the cabinet, I noticed the feet are on some rather thin sheet metal in the corners of the cabinet, so I cut some 1x2" oak stock to fit in the corners of the base, and have the corners of the cabinet sit on those. That worked. It sits nice and tight.
It would have prevented a lot of trouble if I had just taken the plastic feet off in the first place.

__________________
Mike - Retired FoMoCo Tradesman
My Gallery @ http://www.routerforums.com/axlmyks-stuff/

Corybant

Hello Mike: are you planning on attaching the out-feed table to the saw? If so, any thoughts on how to do it?

Corybants (Bill)