| |
| | Register Now!It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community! ** Registration removes majority of the website advertisements ** | |
| ||||||
| Tools and Woodworking Mainly for general woodworking questions and comments you may also come here to ask questions, get advice and share your experience with power tools. |
New Reply |
| | Thread Tools | Display Modes |
05-31-2005, 01:38 PM
| #1 |
| Registered User New Member |  tenon cutter i saw bob using a tenon cutter that cut 1/2 deep. i cant find one,where do you find one like he uses |
| Top - Reply with Quote |
 Sponsor Post
| |||
| Advertising
| Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Router Forums | ||
|
05-31-2005, 03:22 PM
| #2 |
| Marine Engineer Forum King  | I think that one is only available as part of their mortise and tenon kit. I use an 1-1/4 straight bit (it's actually a pattern bit), and just cut one cheek at a time.
__________________ Doug 1 John 1:9 |
|
| Top - Reply with Quote |
New Reply |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tenon sizes | ACV | Table-mounted Routing | 11 | 03-20-2008 03:46 PM |
| Special rabbet/rebate cutter..... | challagan | Router Bits - Types and Usage | 8 | 01-31-2007 07:58 PM |
| Slot Cutter or Spline cutter | kimbert | General Routing | 3 | 10-20-2005 07:26 PM |
| mortise and tenon system | kellyp | Jigs and Fixtures | 1 | 02-15-2005 04:36 PM |
| Mortise and Tenon Joints | TheVogon | Table-mounted Routing | 3 | 09-28-2004 11:15 PM |
Linear Mode
