| | Register Now! It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community!
** Registration removes majority of the website advertisements ** | |
| ||||||
| This is a discussion on blade lube within the Tools and Woodworking forums, part of the General Woodworking category; i do alot of re-sawing 8-12 inch boards and i have found this lube Slick ... |
New Reply |
| | LinkBack | Thread Tools | Display Modes |
04-11-2009, 07:46 PM
| #1 (permalink) | ||
| Registered User   |
i do alot of re-sawing 8-12 inch boards and i have found this lube Slick Stix to be wonderful Merlube Metal Cutting Lubricants - Lube, Saw, Oil, Coolant - Aluminum Sawing Experts  i use if all the time causes the blade to last longer and and glide thru a cut if u contact them i think they still send out samples if they dont i really recommend it. Also a (TIP ) i put a coat on the blade if im changing size so it dont rust on the shelf wait to be used again. You dont need to use alot but i put a coat on each time im making a big cut, a stick will last a long time i think its under 4.00 | ||
|
 Sponsor Post
| ||||
 Sponsored Links __________________ This advertisment post is not shown to registered members. Register your free account today and become a member of Router Forums | ||||
|
05-01-2009, 04:56 PM
| #2 (permalink) | ||
| Registered User   Join Date: May 2007 Location: I was born and raised in Holland Michigan First Name: Howard Posts: 1,529  |
Thanks, Is there any problem with paint, or stain after using it?
__________________ John 3:16 Please fill out your profile, It helps us to know you better  | ||
|
|
|
05-01-2009, 07:03 PM
| #3 (permalink) | ||
| Registered User |
i usually plane the wood down afterward but on the items i have cut for a local craft store paints and stains them has never complained.....send for a free sample and check what your results are. ive been using the lube for a few years now and i really like it | ||
|
|
New Reply |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Forrestt II thin kerf blade | Birch | Tools and Woodworking | 22 | 04-11-2009 11:59 AM |
| 10" blade selection?? | jeep_man | Tools and Woodworking | 27 | 04-10-2009 04:57 PM |
| "Lo-tech" table saw blade alignment | simplenik | Tools and Woodworking | 4 | 04-10-2009 12:27 PM |
| table saw blade selection | blurry | Tools and Woodworking | 19 | 03-13-2009 12:12 PM |
| which rip blade to get? | rprice54 | Tools and Woodworking | 11 | 06-15-2008 06:51 AM |
Linear Mode
