| ||||||
It appears you aren’t a registered member of the Router Forums community. Why not spend less than a minute and register for the oldest and largest router and woodworking community on the web! Join in over 29,500 discussions with over 65,000 woodworkers. If you’re an experienced or beginner woodworker, your questions and knowledge is always warmly welcomed by our community. Register now for your FREE account!| This is a discussion on Home Made Cam Clamps... within the Tools and Woodworking forums, part of the General Woodworking category; I have just updated my web page collection with an article by Sam Howe titled ... |
New Reply |
| | LinkBack | Thread Tools | Display Modes |
10-19-2006, 06:21 PM
| #1 (permalink) | ||
| Registered User   |
I have just updated my web page collection with an article by Sam Howe titled Home Made Cam Clamps. I think it's a Super article... I hope you do too... Under Jigs & Tools http://woodworkstuff.net/HoweClamp.html Enjoy! Last edited by Joe Lyddon; 10-19-2006 at 06:36 PM. | ||
|
|
Sponsored Advertisement - Register now to remove this advertisement.
|
|
** Please be sure to read our Disclaimer at the bottom of the page. **
These advertisements are only displayed to guests, register now for your FREE account on the worlds largest router and woodworking community! |
|
11-28-2006, 09:29 PM
| #2 (permalink) | ||
| Registered User  |
Joe , I just finished looking at the cam clamp file and like you idea. I have some hard maple in my shop and will try some as soon as I get a chance to. Great idea ! Roger | ||
|
|
New Reply |
| Bookmarks |
| ||||||
It appears you aren’t a registered member of the Router Forums community. Why not spend less than a minute and register for the oldest and largest router and woodworking community on the web! Join in over 29,500 discussions with over 65,000 woodworkers. If you’re an experienced or beginner woodworker, your questions and knowledge is always warmly welcomed by our community. Register now for your FREE account!| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| overcomming home made router table snags | matey | Table-mounted Routing | 5 | 01-27-2011 07:36 PM |
| home made router table | vegeta88 | Table-mounted Routing | 19 | 12-31-2008 03:30 PM |
| home made suction bed? | teabag | Jigs and Fixtures | 7 | 12-17-2007 08:58 PM |
| Which base do I use on my home made table? | popeyebedford | Table-mounted Routing | 1 | 07-08-2007 01:56 PM |
| Home made mitre fence? | normcatalunya | Jigs and Fixtures | 9 | 11-01-2005 02:51 AM |
Home Made Cam Clamps... 
Linear Mode
