| |
| | Register Now!It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community! ** Registration removes majority of the website advertisements ** | |
| ||||||
| Tools and Woodworking Mainly for general woodworking questions and comments you may also come here to ask questions, get advice and share your experience with power tools. |
New Reply |
| | Thread Tools | Display Modes |
01-01-2007, 12:14 PM
| #1 |
| Registered User Forum Geek |  Checking diagonals Good day You know those two sticks that are called Bar Gauge, to check the diagonals while gluing-up carcasses or frames. After messing the sharp end with glue so many times, I decided that its time to improve them. And that's what I did... niki      Last edited by simplenik; 05-27-2007 at 10:52 PM. |
| Top - Reply with Quote |
 Sponsor Post
| |||
| Advertising
| Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Router Forums | ||
|
01-01-2007, 03:56 PM
| #2 |
| Senior Moderator Supreme Forum King  | I have always simply measured the diagonals for square.
__________________ Mike Please edit your profile with a name and location so we can better assist you. |
|
| Top - Reply with Quote |
|
01-01-2007, 04:46 PM
| #3 |
| Registered User Forum Geek | But Mike, probably many others are measuring diagonals, otherwise, they would not sell two pieces of plastic for $15...  http://www.highlandwoodworking.com/b...uge-Heads.html niki |
|
| Top - Reply with Quote |
New Reply |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Checking it out | glg | Introductions | 2 | 04-06-2006 01:11 AM |
Linear Mode
