My big mistake- v- drum sander

[trap]

I did not buy the sander from stockroon Supply, but I called them about the angle you cut sand paper. They told me it is the same as the paper that comes on the drum..
bobj or challenge can you give me a hint.
Bud

[bobj3]

Hi Bud

It's cut on a 45 deg. a sharp 45...with the tip cut off ,if you want a snapshot just ask and I will post one...


==========

Originally Posted by trap

I did not buy the sander from stockroon Supply, but I called them about the angle you cut sand paper. They told me it is the same as the paper that comes on the drum..
bobj or challenge can you give me a hint.
Bud

[trap]

Thanks bobj... After thinking about, I saw lines on the drum. Have a lot of vecro laying around. Put it on backwards, following the lines on the drum. cut the end off, took it off turned it over and went to the left side and put it on. There is no cut off end, like the video on then at stock room. I will cut one at 45 degrees and square it off and see if that is better.
Thanx again
Bud