| | Register Now! It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community!
** Registration removes majority of the website advertisements ** | |
| ||||||
| This is a discussion on Backer board for Katie of Gifkins within the Tools and Woodworking forums, part of the General Woodworking category; Does anyone know the best method of replacing the mdf backer board that comes with ... |
New Reply |
| | LinkBack | Thread Tools | Display Modes |
06-21-2008, 09:44 PM
| #1 (permalink) | ||
| Registered User  |
Does anyone know the best method of replacing the mdf backer board that comes with jigs like the Katie or the Gifkins? It is not standard sized MDF. Would pine or aspen work, if paned down to the dimension? Any thoughts? Thanks Steve Bolton | ||
|
 Sponsor Post
| ||||
 Sponsored Links __________________ This advertisment post is not shown to registered members. Register your free account today and become a member of Router Forums | ||||
|
06-21-2008, 11:21 PM
| #2 (permalink) | |||
| Forum Contributor   |
HI Steve Not sure why you want to replace it..  The new one will look the same after you use it a time or two.. But if you went to far and damage it ...you can use just about any thing you have on hand the FLAT and true...but this time put in a tee slot that you can use for clamping the stock in place.. ==== Quote:
__________________ MLCS Instruction Pages & Videos plus FREE MLCS Project Plans http://www.mlcswoodworking.com/shops.../instruct.html Part Finder find parts for your power tools http://www.ereplacementparts.com/ Need some help replacing the parts http://forums.ereplacementparts.com/ Many Router Tips from RWS http://www.routerworkshop.com/router_tip_glossary.html http://www.routerforums.com/email-ro...-members-only/ Router Tables ,Ready to use http://www.rt1000.com/ http://rt1000.com/_wsn/page2.html Bob J. | |||
|
|
New Reply |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cutting groove in cutting board | Ken Brown | Jigs and Fixtures | 7 | 01-06-2010 09:57 AM |
| Finally Got The Gifkins Set Up..... | challagan | Jigs and Fixtures | 25 | 03-23-2007 10:07 AM |
| Router Table as shooting board ? | Bob N | Jigs and Fixtures | 9 | 03-14-2007 05:14 PM |
| Cutting board and dovetail joinery | rzaccone | Table-mounted Routing | 2 | 05-12-2006 10:14 AM |
| Cutting Board | woody | Show N' Tell | 3 | 04-02-2006 03:32 PM |
Linear Mode
