| |
| | Register Now!It appears that you aren't a registered member, click below to instantly register and become a member of the RouterForums.com Community! ** Registration removes majority of the website advertisements ** | |
07-03-2008, 09:24 AM
| #1 |
| Registered User Forum King  |  TS blade with square corner cut? I'm trying to find a blade for my table saw that leaves a crisp, square corner in the cut. I've been to the Freud website, but they give no indication of how the teeth on the blades are set. A full kerf blade is preferred. I want this for when I cut tenons.
__________________ Mike - Retired FoMoCo Tradesman My Gallery @ http://www.routerforums.com/axlmyks-stuff/ |
| Top - Reply with Quote |
 Sponsor Post
| |||
| Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Router Forums | |||
|
07-03-2008, 09:41 AM
| #2 | |
| Forum Contributer Supreme Forum King  | Hi Mike You may want to check out/use a Dado saw blade set with or without spacers ...  works great with a scrap board and the Delta teton jig one pass and it's done.. ========= Quote:
__________________ Bj Last edited by bobj3; 07-03-2008 at 09:54 AM. | |
|
| Top - Reply with Quote |
|
07-03-2008, 11:37 AM
| #3 |
| Marine Engineer Forum King  |
__________________ Doug 1 John 1:9 |
|
| Top - Reply with Quote |
|
07-04-2008, 05:39 AM
| #4 |
| Registered User Forum King | Thanks for the suggestions. All I'm looking for is a 10" blade.
__________________ Mike - Retired FoMoCo Tradesman My Gallery @ http://www.routerforums.com/axlmyks-stuff/ |
|
| Top - Reply with Quote |
|
07-06-2008, 05:20 PM
| #5 |
| Registered User Forum King | Well, I went and bit the bullet. Got the Freud Diable dado set. Should have gone that way in the first place instead of quibbling over it. 
__________________ Mike - Retired FoMoCo Tradesman My Gallery @ http://www.routerforums.com/axlmyks-stuff/ |
|
| Top - Reply with Quote |
New Reply |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| which rip blade to get? | rprice54 | Tools and Woodworking | 11 | 06-15-2008 06:51 AM |
| Forest 10" 80 tooth Chopmaster Blade | rstermer | Tool Reviews | 0 | 05-13-2008 02:31 PM |
| Corner Radius | bobj3 | Tools and Woodworking | 25 | 09-29-2007 05:51 PM |
| "Lo-tech" table saw blade alignment | simplenik | Tools and Woodworking | 1 | 07-08-2007 05:06 PM |
| Square fence | Drick | General Routing | 5 | 03-30-2005 02:17 PM |
Linear Mode
