Router Forums - View Single Post - Craftsman fence problem
View Single Post
post #7 of (permalink) Old 02-22-2009, 02:05 AM Thread Starter
Registered User
Barry99's Avatar
Join Date: Feb 2009
First Name: Barry
Posts: 189

I will check my fence Gerry. The fence came already asembeled, even though the directions shows it needs to be put together. I do not understand the natural design offset part. If I have a piece of wood and say I want to route the bottom edge with a roundover, as the peice is being push, it will hit the outfeed and move away from the cutter because the infeed is around 3/64" back further.
Originally Posted by Gerard_sr View Post
I think Chuck is right, but.
There would be a natural design offset of about that amount if both the infeed and outfeed fences are pushed back to their limits.
The only other possibility is having the two washers on the outfeed side in the wrong place, they should be under the wing-nuts and not (possibly) elsewhere.

See attached diagram of the unit.



~Is it measure twice and cut once, or cut twice and measure once?~
Barry99 is offline  
For the best viewing experience please update your browser to Google Chrome