Router Forums - View Single Post - Router table insert rings lower than table top
View Single Post
post #8 of (permalink) Old 07-10-2011, 12:29 PM Thread Starter
jmoore65
Registered User
 
Join Date: Aug 2008
Country: United States
First Name: Jim
Posts: 32
 
Default

Thanks for the idea. I made some progress resolving my flatness problem.

First, I realized I was testing flatness wrong. If I place the straightedges across the middle of the table I see the same small gap on either side. This looks more like a slight crown than a warped plate.

Second, I used some tape and shimmed up one side of the insert ring so no more catches.

However, the insert ring is not flat. It slopes inward quite a bit. So I'm looking at getting a replacement.

Finally, one of the mounting holes was drilled slightly off and when I tightened the screws down hard I heard a small "snap" and noticed plate had bowed. I elongated the errant hole and did not tighten that screw too hard. This time, the router plate did not deform.

Last edited by jmoore65; 07-10-2011 at 09:52 PM.
jmoore65 is offline  
 
 
For the best viewing experience please update your browser to Google Chrome