Very Nice Dad
Now the trick is to keep them in it, little curtain climbers
I would like to know the same as Harry ? ?
This is what I use to get the job done, on the drill press , ▼ at one time I used my Shop Smith to do that type of job also,because I could clamp it to the table,in a small guide board jig.
TENON CUTTERS http://www.mlcswoodworking.com/shops.../plgtenon.html
JUST a NOTE**** Bob and Rick made a neat jig to get pins on the styles just right in the center of the style and right on the right spacing, neat jig, it's was done with a plunge router, it was for a table but it would work for just about any job like the one you did Dad.
Plus Rick made a glue up jig for the same type of joint, when you have many items to line up at one time
Episode 1106/1107 Chair-side Table, 2 Parts http://www.routerworkshop.com/series1100hilites.html
A fine oak furniture piece with a modern touch, the chair-side table can be used in the bedroom, the living room or the family recreation room. Router joinery by Bob and Rick Rosendahl make this table sturdy and esthetic by incorporating mortise and tenon joinery with the router.
Watch episodes #1106 and #1107 for design and construction details.
1106. Chair-side Table Part 1
1107. Chair-side Table, Part 2