Router Forums banner

Mach3 or 4 vs UCCNC

8K views 3 replies 4 participants last post by  difalkner 
#1 ·
New cnc router will be up and running soon. Wondered if opinions and experience would be shared on these two softwares?

Advantages? Abilities? Use of penants and such?
 
#2 ·
DARRELL81,
I cannot speak for others, but also being new with CNC, i use Vectric Software. i have used Mach 3, but no nothing of UCCNC. I found for me it was and is easier to use the Vetric and that is also the software provided by the company who i purchased my machine. Not much help, I know, but my preference at this time.
 
#3 ·
#4 ·
I'm fairly new to CNC but started with Mach4 controller software and the Ethernet Smooth Stepper for the interface. So far this has been reliable except for when I've done something to mess it up, but I guess that can happen with any software/hardware combination.

David
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top