Router Forums banner

MT Stringer had an idea and ............

3K views 12 replies 9 participants last post by  honesttjohn 
#1 · (Edited)
this is what we came up with. Maybe this helped a little in getting him interested in "acquiring" his own CNC. These are about 20x10.



Course I had to do the "other" school, too.




These are cut from Corafoam and painted with acrylics. The sloppy paint job is the fault of either the paint or brush, or both.

Once, MEBCWD showed me how easy (for him) it was in Aspire to make em pointing right and left using the same models I just kept cutting. Got a couple more waiting for me to decide what colors to use. Used 1 piece of Corafoam and cut 3 out at a time.
 
See less See more
2
#11 · (Edited)
I'm sure not the one to ask about painting - - not my strong point by any stretch, although I wish it was. That's why I use wood and stain most everything. Wish I could paint -- then I would be carving a lot of Corafoam and buying acrylic paint by the large sizes instead of the hobby tubes.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top