Router Forums banner

Tool is stuck in the profile 408 Head (CNC)

2K views 2 replies 2 participants last post by  Qualitysrd 
#1 ·
Good morning and GOD Bless you.

The company I work for has a Gerber Profile 408. We are getting a clamp release error. Has anyone experienced this before?

Thank for you time.

Gerry Waldron
 
#2 ·
Gerry welcome to the Router Forums.

Gerry you might check your air line going to the ATC and make sure it is clear and not full of water. If the moisture trap on the air line filled up and was not bled off then moisture could have gotten into the ATC system keeping it from operating correctly. This would give you a clamping error.

I know around here we have had really high humidity levels this year.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top