Played around today.I think I had model set at .5 inch and material at .75. Did rough cut and it took it all down. Then changed bit and did finish. It was about 1/8 inch above the rough cut.I set z zero on top of material.
Back to drawing board and I see it rough cuts over whole model. I set model boundary.how do I get it to only rough/finish the contoured edge?
I've been watching videos all day,12 so far. Started from beginners #1....my eyes are bleeding......
Oh and Tinkerbell, I tried 60 degree 1/4 inch v groove at .02. Barely cut in but still a lot of tearout or overlap.ready to try a Finnish nail.