My question would be easy to understand if I had a picture, but I can't seem to find one.
I would like to make a small clock, say 6" x 8" x 3" deep, and the top would be shaped like a "flattened bell". What is the best way to make the decorative edge on the front and sides on that "flattened bell". In essence, I would need to put a decorative edge on a curve (front) and then straight edges (the two sides).
Also, what is the best way to make the broken arch that is common to grandfather clocks?
Thanks in advance for any input you provide.
John
I would like to make a small clock, say 6" x 8" x 3" deep, and the top would be shaped like a "flattened bell". What is the best way to make the decorative edge on the front and sides on that "flattened bell". In essence, I would need to put a decorative edge on a curve (front) and then straight edges (the two sides).
Also, what is the best way to make the broken arch that is common to grandfather clocks?
Thanks in advance for any input you provide.
John