Router Forums banner
1K views 3 replies 4 participants last post by  jschaben 
#1 ·
i need to make an ogee profile on a glued /laminated piece of pine. I am afraid that as I rout the radius the end grains will not clean up as well as the with the grain area? help
 
#2 ·
Greetings (your name here) and welcome to the router forum.
 
#4 ·
Welcome to the forums,
You may be right but a little more detail would be helpful. Without a clue as to what you are trying to do, I would suggest you treat it as though the entire profile is end grain and make a lot of very small cuts.
Good Luck,
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top