Router Forums banner

Raised Panel Edge Detail

2K views 2 replies 3 participants last post by  bobj3 
#1 ·
I made some cherry raised panels for a tall pantry cabinet. The doors are 25/32" thick with a 1/2" deep 35mm hole for the hinges. On the inside or the rails an stiles it has an ogee detail. Instead of leaving the other side of the rails and stiles flat, what kind of detail could I put on it and not have it go so deep and open up the hole for the hinges?

I posted this question on another board and only got 2 responses, what do you all think here?
Nick
 

Attachments

See less See more
1
#3 ·
Hi Nick

You may want to use a 1/8" round over,just to clean up the edge, if you nick the pocket hole it's done and it's a very hard fix. :(


==========
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top