Router Forums banner

do the nobs (handles) screw off

2K views 6 replies 3 participants last post by  The Illustrator 
#1 · (Edited)
I just purchased a Porter-cable 6902 with an 6931 plunger base from my local pawn shop. I was wondering if any one had any ideal on if the knobs (handles) on the base screwed off. I tried by hand put they don't move and I do not want to break them if they are not suppose to come off.
PS. looks like I forgot to put the (K) in knobs in the title, o well.
 
#2 · (Edited)
Hi Scott

Most have bolts holding them in place,,,look inside of the base for the bolt heads,then pull your socket wrench out and remove them,,don't forget lefty loosie ,right to tightie :)



======

I just purchased a Porter-cable 6902 with an 6931 plunger base from my local pawn shop. I was wondering if any one had any ideal on if the nobs (handles) on the base screwed off. I tried by hand put they don't move and I do not want to break them if they are not suppose to come off.
 
#5 ·
Hey Doug

Thanks for the Schematics, I need to take the knobs off for the router to fit it in my table, but I would sure hate to bust them up. Looking at the schematics I may put a rag around the knob and use my channel locks to apply a little more pressure and see what gives. Thanks again and wish me luck, lol.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top