Router Forums banner

routing inside decorative corner

2K views 2 replies 3 participants last post by  jschaben 
#1 ·
hi there, new to the forum and my first question is this, I am building a cutting board for my daughter and want to put a troth for juices to flow but how do I rout the inside corners , tyvm
tumbleweed (newbie)
 
#2 ·
Greetings (your name here) and welcome to the router forums.
 
#3 ·
Hi Tumbleweed, welcome aboard. I'm a little new to routing myself so I am sure there will be others in here with more elegant solutions but I would be inclined to make a template from MDF or similar and use a guide bushing. Cut your template 1/8" smaller than the trough and cut it out with a jigsaw or bandsaw. Attach to the cutting board with double face tape and follow it around with a 3/4" bushing and 1/2" roundnose or bowl bit.:)
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top