Veneer edging - Router Forums
LinkBack Thread Tools Display Modes
post #1 of 2 (permalink) Old 12-17-2010, 10:54 PM Thread Starter
Registered User
Join Date: Dec 2010
Country: United States
First Name: N/a
Posts: 1
Cool Veneer edging

Hey guys, haven't worked with a router in a while, and when I did it has been a while. I put some veneer edging on an oak fixture. Was wondering what type of bit I would use to make it flush with the top. As I used 3/4 on a 1/2 piece of oak, it needs to be trimmed. As far as I knew from previous times i overhung it on each side. In any case, I'm just in need of what type of router bit i needed.

Picked up a nice set of freud bits in a set of about 50 for a couple hundred dollars from a previous employer, so i pretty much have all kinds. Also wondering what to use to clean up the holes in it. For reference, this a dog food bool holder.
gwallman31 is offline  
Sponsored Links
post #2 of 2 (permalink) Old 12-17-2010, 11:56 PM
Registered User
Join Date: Mar 2009
Country: United States
First Name: Paul
Posts: 265

Flush trim bit.

Dont forget to live life for fear of death grasp each day and live it to it full otherwise it is pointless.
newwoodworker is offline  

Quick Reply

Register Now

In order to be able to post messages on the Router Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode

Similar Threads
Thread Thread Starter Forum Replies Last Post
Veneer hammer rwyoung Show N' Tell 8 05-16-2010 10:52 PM
best way to route a frame style edging? sf_basilix General Routing 6 02-11-2010 07:30 AM
Hardwood edging on router table build the_nite_owl Table-mounted Routing 22 11-03-2009 01:17 AM
Trimming mitered hardwood edging Drew Eckhardt General Routing 5 10-11-2008 08:59 PM
Walnut Burl Box Build Along (1st Veneer Project) Nickbee Show N' Tell 38 03-18-2008 06:17 AM

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On

For the best viewing experience please update your browser to Google Chrome