I believe the PC7518 and a Milwaukee? router have the same hole settings as the Triton.
If they are listed, use those settings.
Once you have the router attached to the plate, you can use 5/16" ID guide bush to set the centre. Use a 1/4" drill bit in a 1/4" collet.
If you do not intend to use guide bushings in the plate, then centering to /1000" is not all that important...
I don't mind if other members disagree with my comments.
I don't profess to know everything, and I may learn something new.
"Never attribute to malice that which is adequately explained by stupidity."
Last edited by jw2170; 06-26-2014 at 08:01 PM.