You can make you own easy, take a trip down to the Ace Hardware and pickup some BRASS rod ( 3/8" dia.) pull your die set out of the tool box and thread one end then cut it off to the size you want it to be ,,,,you don't want to use a steel bolt for this job, if it comes out or rolls over to the router bit you don't want steel hitting steel ,,,your router bit...the brass rod is cheap and use it for many jobs in the shop,,,some Ace hardware do have brass bolts but most don't, so to say if you find one the right thread size and some untreated part on the brass bolt you can just cut it off on both ends so you have a short thread on one end and some blank on the other end,,,you don't want to use a bolt that has threads, it should be smooth so the stock can go by it without hanging up...
Below you will see the ones I made with some brass rod..
If it's worth doing it's worth it to do it right...
If yo don't want to make your own you can give MLCS a call and ask them if they have a replace one in stock, they sale the plates with them but don't just list just the pin...it's a free call 800 number
with some luck they just may have one... http://www.mlcswoodworking.com/shops...re/mlcsfaq.htm
Originally Posted by jjr9999
Where can I find a safety guide pin for sale?
My plate has a threaded hole for one, but either one was not included or I lost it.
I looked online and there are none to be had, unless there's a plate included.