Yep I thought you would see this one
You'er welcome, that's a real draw back about the K2000, is the mess it makes but now you and I and others can have a clean work shop with just a little vac.port, it's a bit tricky to make the press fit vac port but with the plastic snap on the top it will stay in place and do the a good job sucking up the chips...
I just hate to blow out the chips after I drill one or two holes but now it's clean and ready for the next board...
The Mfg. (Kreg) must have got many users asking for one and they put it on the K3 model and it's big sellling point I'm sure...
I don't recall seeing any other of the pocket holes jigs have one yet..
Note the pull up stop blocks on the new K3 model and it's a great item also but the slide blocks do the same thing but just a bit better...
many times I will do some 3" wide or wider stock and the stops just don't do the trick..it was always just a guess where to put the stock for drilling but now the guess work is gone.
Note::they dropped the support blue blocks on the side of the K3 jig model and that's a neat item to have for the pocket hole jig, they supports the longer boards
, not to sure why they dropped them but you can add them to the K3 model easy...the longer the better
Originally Posted by challagan
Well, you had to know I would see this
That's cool BJ. I will add this to my favorites and hopefully I can get around to doing at least the DC chute. Nice one BJ and thanks for all the photos as usual!