I am Rav. I am new to routing. I was tring to configure two CISCO 2600 router on a simulator. I created two virtual router one on DCE and other on DTE. Both router was having the IP as 192.168.1.1 and 192.168.10.1 on s0/0 and s0/1 respectively on 255.255.255.0.
On the router which was added on DCE I had enable clock rate to 64000 with no shutdown for both the router.
I had added the following command for routing...
ip route 192.168.10.0 255.255.255.0 192.168.10.1
ip route 192.168.1.0 255.255.255.0 192.168.1.1
Once after setting these config and saving the changes using write command I was not been able to ping each other.
Kindly advice the appropriate changes which is required for this to ping each other... I tried with Router RIP here with router rip it works fine...
Looking forward to your suggestion on this !!!
Thanks and advance.... I know it's quite easy for you guys but belive me right now I am stuch over here
Well first off welcome to the forms, And the now the bad news... this is not a router forum for personal computing. This is a woodworking forum, But hey you never know their are some very knowlagable folk on her and perhaps you will get your answer