Router Forums banner
Cancel
Add bookmark
This is the view from the top, showing the nifty adjustment crank. With the Triton, you don't need a router lift, you can raise and lower the bit by

This is the view from the top, showing the nifty adjustment crank. With the Triton, you don't need a router lift, you can raise and lower the bit by

  • 0
  • 0
The view from under the table. I had to cut the Jet factory crossbrace to fit the router in there. I'll add two more later on each side of the route

The view from under the table. I had to cut the Jet factory crossbrace to fit the router in there. I'll add two more later on each side of the route

  • 0
  • 0
simonov

Triton TRA001 3¼ HP router in table saw extension

As soon as my new Triton router arrived I installed it in the extension table of my table saw. This is meant to be a temporary set-up, as I intend to produce insert plates to which the router will be attached in the future, instead of bolting it directly to the table top.
Click to expand...
There are no comments to display.

Album information

Album owner
simonov
Date created
Item count
2
View count
94
Comment count
0
Rating
0.00 star(s) 0 ratings

Album privacy

simonov

simonov

Media items
2
Albums
1
Can view media items
Everyone
Can add media items
Album owner only

Share this album

Top