I needed some doweling to cover screw and lag bolt holes in a project and came up with this....... It is a slide vice, I bolted to the lathe bed and

Some logs I picked up this winter, a tree fell over my friends driveway so I went and cut it into logs loaded it on the trailer and made some good woo

My new Hudson band mill, well it was new three years ago. This has been the handiest investment I have ever made. This ranch has a lot of out buildi

Quite the handy little tool.

I needed some doweling to cover screw and lag bolt holes in a project and came up with this....... It is a slide vice, I bolted to the lathe bed and

My wife's favorite tool.... well besides her scroll saw and mini table saw anyways...

I can even cut small octagonal posts up to about 8 to 10 inch wide and up to about 12 feet long with this set up..

A simple setup I made to cut octagonal wood on the mill for the wife to use on the lathe.

I needed some doweling to cover screw and lag bolt holes in a project and came up with this....... It is a slide vice, I bolted to the lathe bed and

Mountain
Jun 5, 2015

Watch Add bookmark

There are no comments to display.