FreeTime FreeTime is offline
- My Shop
Some detailed information about my workshop.
- Power Tools
- Basic Tools -
Router, Biscuit Joiner
SawStop Table Saw w/sled
Bench Drill Press
Router Table (shop made)
Miter Saw / DeWalt 13" Planer
Vintage Craftsman 6" Jointer
- My Shop
- Garage bay, fortunately the car doesn't mind the weather outside.
- Woodworker Information
A few details about myself.
- A software developer who is trying to spend less time in front of the dual monitors.
- New Hampshire
- Spending time on my ST1300
- Favorite Router
- Bosch Colt with Plunge setup
(2) DeWalt 618 routers
PC 890 (in the table)
- Woodworking Experience (Years)
- First Name
- United States
Showing Friends 1 to 1 of 1
- Registered User
- mbar57 is offline
|02:33 PM - JOAT quoted FreeTime in post To CAD or not to CAD |
the last thing I want to do i...
|11:08 AM - qulevrius quoted FreeTime in post Table saw fence |
It is nice to have a saw with...
|06:59 PM - vchiarelli quoted FreeTime in post Finally insulated my garage! |
You've been taking a lot of g...
|08:56 PM - Cherryville Chuck quoted FreeTime in post Keyhole bit usage |
I feel like things come to a ...
|11:45 AM - SteveMI quoted FreeTime in post Router bit diameter tolerance |
You mentioned a "set of 3" (R...
|06:26 PM - Jerry Bowen quoted FreeTime in post Jointer technique |
Thanks for the help guys. Ch...
|01:54 PM - OutoftheWoodwork quoted FreeTime in post NOW I'm Pi$$ed!!! |
I've always found the oil bas...
|04:00 PM - Cherryville Chuck quoted FreeTime in post Plunge bits?? |
My vote is with the hand held...
|04:14 AM - DesertRatTom quoted FreeTime in post Honing Guide |
I was glad to have acquired a...
|12:28 AM - Murtu01 quoted FreeTime in post Drill press laser device |
Have one (buit in), used it a...
|07:01 AM - Nickp quoted FreeTime in post Table Sled Runners - The hunt continues... |
Tried UHMW - went back to Map...
|02:20 PM - DaninVan quoted FreeTime in post Good Excuse to buy Router Bits |
Well I was thinking I needed ...
|05:37 PM - mbar57 quoted FreeTime in post Prototype "Micro" Adjuster |
Mike, If I'm seeing this c...
|10:08 AM - harrysin quoted FreeTime in post Shop notes wooden mallet |
I needed a wooden hammer to u...
|01:46 PM - RÖENTGEEP quoted FreeTime in post Crosscut Sled Zero Clearance Insert |
Has anyone attempted or had s...
|03:46 PM - rwl7532 quoted FreeTime in post Jointer Refurbishment |
It seems to be a fairly well ...