Router Forums

Router Forums (https://www.routerforums.com/forum.php)
-   New Member Introductions (https://www.routerforums.com/new-member-introductions/)
-   -   worry about the right 27" fence to my new table (https://www.routerforums.com/new-member-introductions/44669-worry-about-right-27-fence-my-new-table.html)

rockinRoland 01-14-2014 08:22 PM

worry about the right 27" fence to my new table
 
this is my first post and I must say I am very excited to say that I need help to find the right moderate cost fence single face for my new 27" wide phenolic (sp) top. Really not needing a totally split fence but I am a novice at routing and trying to set up the best versatility and still pay the bills. There is nothing on this table except the plate opening for the plate. Thanks for the help. R

MT Stringer 01-14-2014 09:11 PM

4 Attachment(s)
You could make your own fence. It is not rocket science. Search for Steve Ramsey on You Tube. He made a router table and fence. It is nice. Not too complicated and should be something you can base your fence on.

I made my own table top and fence. Works just fine for me.
Note: A split fence can be useful. Make or buy it if you can.

old55 01-14-2014 10:19 PM

Welcome to the forum.

jw2170 01-14-2014 10:48 PM

A jointed piece of 2X4 clamped to the table, is as simple as it gets.

Or as suggested by Mike, make your own.

Start with a length of 4x4 angle aluminum.

Willway 01-15-2014 06:47 AM

The video Mike was talking about is below. The fence build starts about half way through. Very easy to build.

Router table top and fence - YouTube

Cherryville Chuck 01-16-2014 12:28 AM

I built a split fence out of mdf and particle board scraps. The only thing that cost money were the bolts and knobs and a few biscuits. There is a picture of it in my uploads. It worked really well.

rockinRoland 01-16-2014 11:36 AM

Thanks Mike I really appreciate the reply and the reference...I will definitely check it out.
I appreciate the pictures too. Very nice work and encouraging for me as a first timer. Roland

rockinRoland 01-16-2014 11:38 AM

Thanks Ross !

rockinRoland 01-16-2014 11:41 AM

Thank you James for the supportive reply and suggestion about the angle iron. I will follow that idea up. Roland

rockinRoland 01-16-2014 11:43 AM

Thanks for the easy reference and I will be going there immediately following this reply. Very helpful!


All times are GMT -5. The time now is 05:26 AM.

Powered by vBulletin® - Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.


vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
User Alert System provided by Advanced User Tagging (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.