I am a new member to your group, I am fairly new to woodwork, and though have a good general knowledge of DIY. I am getting ready for retirement in a few years and want to stay active, I have been putting together a small workshop, (14 x6 feet) over the last 2 years, I now have a table saw, (Jet) a bench router table, (Kreg), and a bench pillar drill. I have 2 routers, both De Walt, a 1/4 and a half inch, am hoping to build a router table using the top from the kreg bench soon, with a lift in it.
I was bought for xmas a set of round over bits and went to use one today but, seem to have a 3/8 shaft? I have never come across this size before? Can anyone tell me if there is a colet that I can use in my 1/2 De Walt to get some use out of them???